IBM Gigabit Ethernet-SX PCI-X Adapter and Dual..., Инструкция по установке и использованию

Страница: 23 / 32

Chapter 5. Connecting to an Ethernet Network
This chapter explains how to connect the adapter to the multimode fiber network. Refer to your local
procedures for information about connecting the Gigabit Ethernet-SX PCI-X Adapter or Dual Port Gigabit
Ethernet-SX PCI-X Adapter to your Ethernet network.
Note: Only one type of network can be attached to the adapter card at one time.
Connecting the Network Cables and Adapter
Before you begin connecting the adapter, make sure you have the hardware listed in “Verifying Your
Hardware Requirements” on page 3.
To connect the adapter to a multimode fiber network, do the following:
1. Insert the male fiber LC connector of the fiber cable into the adapter LC connector.
2. Insert the male fiber LC connector of the other end of the cable into the network switch.
Note: If your switch has an SC receptacle, you need an LC-SC converter cable.
1
2
3
1. LC Fiber Optic Receptacle
2. LC Fiber Optic Plug
3. 62.5/50 MMF Cable
11