IBM EXN1000, Руководство по аппаратуре и обслуживанию, Страница: 37 / 94

Table 3. EXN1000 expansion unit installation process (continued)
Stage Procedure
Is the procedure
required?
For instructions, go
to...
4 Connect the EXN1000
expansion units.
Only in the following
scenarios:
v
If the new system
installation has
multiple EXN1000
expansion units.
v If the EXN1000
expansion unit is an
addition to your
existing system.
See the EXN1000
Installation and Setup
Instructions .
5 Ground the EXN1000
expansion units and N
series storage system.
Yes. “Grounding EXN1000
expansion units” on
page 15, or the
EXN1000 Installation
and Setup Instructions .
6 Connect the EXN1000
expansion units to a
power source.
Yes. “Connecting the
EXN1000 expansion
unit to a power source”
on page 15
If the system was
shipped in a rack, you
must connect the rack
to a power source.
See the documentation
that shipped with your
cabinet.
7
Configure the system. Yes, if the EXN1000
expansion unit
installation is part of a
new system
installation.
See the Data ONTAP
Software Setup Guide for
your version of Data
ONTAP.
Before you begin your installation
Before you install one or more EXN1000 expansion units in a rack, you need
to understand the following information:
v
EXN1000 expansion unit numbering
v Drive addressing
v
Speed setting
v Supported disk drives
v
Drive bay requirements
Chapter 1. Preparing for the installation
7