IBM eserver iSeries 270, Руководство по установке

Страница: 20 / 40

__ 6.
Install the remaining memory cards.
__ 7. When you finish installing all the memory cards, turn the card assembly
over, and slide it into the system unit. Push on both card latches at the same
time. Close the latches when you cannot push the card assembly any further
into the system unit.
__ 8. Reinstall the access cover.
__ 9. You have completed the installation of the memory cards in your system.
Go to “Install system unit covers” on page 24.
Adding memory to the processor card assembly
__ 1. Before you remove the blank filler cards and install the memory into the
card assembly
, read the following:
v
Figure 15 on page 17 shows memory card locations on the main storage
card assembly.
v
Fill positions C and D before installing memory cards in positions E , F , G ,
and H .
v
Install memory in sets of four. For example, you cannot fill only positions
E and G and later fill positions F and H . You must install all four memory
cards at one time.
v
Pairs of memory cards must be either 128 MB, 256 MB, 512 MB, or 1 GB.
Pairs installed in
E and G must match pairs installed in F and H .
v
Go to step 2 on page 17.
Figure 14. Install Memory Cards
16
30xx Memory Card Installation V5R2