IBM eserver 630 6C4, Руководство по обслуживанию, Страница: 527 / 573

Appendix E. Install a Hardware Management Console (HMC)
The Hardware Management Console (HMC) user interface provides the functions
needed to create and maintain a single or multiple-partitioned environment.
Note: This section refers to systems capable of running multiple partitions. The Model
6C4 and Model 6E4 cannot run multiple partitions. However, your system is
considered a full system partition, and a full system partition allows you to
connect to an HMC and use programs such as Service Focal Point and
Inventory Scout Services. So, when one of the following procedures in this
section asks you to select a partition from a list of partitions, or to configure
additional partitions, keep in mind that your only partition is the one you are
working on.
Position the HMC and Monitor
Position the HMC and monitor at or near their desired location.
v
The HMC weighs between 34 kg (75 pounds) and 41 kg (90 pounds). Do not try to
lift the HMC by yourself.
v
Monitors can weigh as much as 35 kg (77 pounds). Use caution when lifting or
moving the monitor.
v
Leave enough space around the HMC to safely and easily complete the setup
procedures.
v
Observe standard ergonomic guidelines while arranging your system unit so that you
can work comfortably and safely. For more information on arranging your workstation,
visit the Healthy Computing Web address at:
http://www.pc.ibm.com/us/healthycomputing.
v
Be sure to maintain at least 51 mm (2 inches) of space on the sides of the system
unit and 152 mm (6 inches) at the rear of the system unit to allow the system unit to
cool properly. The front of the system requires a minimum of 76 mm (3 inches) of
space. Blocking the air vents can cause overheating, which might result in a
malfunction or permanent damage to the system unit.
v
Place the HMC in a location where all necessary power outlets and network
connections can safely be reached.
v
Place the display in a stable and sturdy location.
507