IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 442 / 573

Operator Panel Replacement
Attention: If you are replacing the operator panel with a new FRU, you must write the
system VPD information (machine type, model number, and serial number) into the
VPD module. You must contact the support center to obtain instructions and the
necessary password to enter the information into the VPD module.
Note: Refer to “System Vital Product Data (VPD) Update Procedure” on page 423 for
the correct procedure.
To replace the operator panel, do the following:
1. Carefully slide the operator panel back into the system bay.
2. Connect the signal and power cable to the connector on the new operator panel.
3. Secure the operator panel with the two retaining screws previously removed.
4. Replace the service access cover, as described in “Service Access Cover
Replacement (Model 6C4)” on page 357.
5. If you are servicing a Model 6C4, push the system drawer back into the operating
position as described in “Returning the Model 6C4 to the Operating Position” on
page 356.
6. Reconnect all system power cables.
7. Replace the front bezel as described in “Front Bezel Replacement (Model 6C4)” on
page 369 or “Front Bezel Replacement (Model 6E4)” on page 370.
8. If necessary replace the bezel door as described in “Bezel Door Replacement” on
page 368.
9. If you are servicing a Model 6E4, replace the top cap as described in “Top Cap
Replacement (Model 6E4)” on page 358.
10. Power on the system as described in “Starting the System” on page 350.
11. If the Model 6C4 has successfully powered on, close the rack doors.
If the Model 6E4 has successfully powered on, close the bezel door.
422 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide