IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 425 / 573

Hot-Plug Disk Drive Removal
Attention: Before you perform the following procedure, ensure that the customer has
taken appropriate actions to back up the data for the drive you are removing, and that
the drive has been removed from the configuration. Physically removing a hot-plug drive
from the system before it has been removed from the system configuration can cause
unrecoverable data corruption. Refer to “Deconfiguring (Removing) or Configuring a
Disk Drive” on page 403.
To remove a hot-plug disk drive, do the following:
1. Before removing the disk, ensure all data has been saved.
2. Deconfigure the drive you are removing from the system. See “Deconfiguring
(Removing) or Configuring a Disk Drive” on page 403.
3. Open the rack front door on a Model 6C4.
Open the front bezel door on a Model 6E4.
4. Remove the front bezel as described in “Front Bezel Removal (Model 6C4)” on
page 369 or the disk drive access cover as described in “Disk Drive Access Cover
Removal (Model 6E4)” on page 365.
5. Locate the hot-plug disk drive you plan to remove. If you are removing a faulty disk
drive, a lit amber LED located at the front right side of each disk drive will help you
isolate the faulty drive.
6. Log in as root user.
7. At the command line, type
smitty
.
8. Select System Storage Management (Physical and Logical Storage).
9. Select Removable Disk Management.
10. Select Remove a Disk.
11. Select the desired disk from the list on the screen and press Enter.
12. Remove the disk drive by placing the handle on the disk drive to the open position
(perpendicular to the drive) and pulling the hot-plug disk drive away from the bay.
The lit LED on the disk drive will turn off when the disk drive is removed.
Chapter 9. Removal and Replacement Procedures
405