IBM eserver 630 6C4, Руководство по обслуживанию

Страница: 399 / 573

Hot-Pluggable PCI Adapter Removal
Note: Removing a hot-pluggable PCI adapter requires the system administrator to take
the PCI adapter offline before performing any PCI adapter hot-plug procedures.
Before taking an adapter offline, the devices attached to the adapter must also
be taken offline. This action prevents a service representative or user from
causing an unexpected outage for system users.
For additional information about taking an adapter offline or removing it from the
system configuration, see the
AIX System Management Guide: Operating
System and Devices. This publication is available at the following Web address:
http://www-1.ibm.com/servers/aix/library/
. Select Technical Publications.
This publication is also contained on the AIX Documentation CD. The
documentation is made accessible by loading the documentation CD onto the
hard disk or by mounting the CD in the CD-ROM drive.
To remove a hot-pluggable PCI adapter, do the following:
1. On a Model 6C4, open the front and rear rack doors, and place the system into
the service position as described in “Placing the Model 6C4 into the Service
Position” on page 355.
On a Model 6E4, open the bezel door.
2. Remove the service access cover as described in “Service Access Cover Removal
(Model 6C4)” on page 357 or “Service Access Cover Removal (Model 6E4)” on
page 363.
3. Determine which adapters you plan to remove.
4. Record the slot number and location of each adapter being removed.
Note: Adapter slots are numbered on the rear of the system unit.
5. Ensure that any processes or applications that might use the adapter are stopped.
6. Refer to “PCI Hot-Plug Manager Access” on page 371, and follow the steps in the
access procedure to select PCI Hot Plug Manager. Then return here to continue.
7. Select Unconfigure a Device and press Enter.
8. Press F4 to display the Device Names menu.
9. Select the adapter you are removing.
10. Use the Tab key to answer NO to Keep Definition and YES to Unconfigure Child
Devices. Press Enter.
11. The ARE YOU SURE screen displays. Press Enter to verify the information.
Successful unconfiguration is indicated by the
OK
message displayed next to the
Command field at the top of the screen.
12. Label and disconnect all cables attached to that adapter.
13. Press F3 to return to the PCI Hot-Plug Manager menu.
14. Select Replace/Remove a PCI Hot-Plug Adapter and press Enter. The
Replace/Remove a PCI Hot-Plug Adapter menu displays.
Chapter 9. Removal and Replacement Procedures
379