IBM EMX0 PCIe3, Установка

Страница: 50 / 72

Starting the system or logical partition
Learn how to start a system or logical partition after performing a service action or system upgrade.
Starting a system that is not managed by an HMC
You can use the power button or the Advanced System Management Interface (ASMI) to start a system
that is not managed by a Hardware Management Console (HMC).
Starting a system by using the control panel
You can use the power button on the control panel to start a system that is not managed by a Hardware
Management Console (HMC).
To start a system by using the control panel, complete the following steps:
1. Open the front rack door, if necessary.
2.
Before you press the power button on the control panel, ensure that power is connected to the system
unit as follows:
v All system power cables are connected to a power source.
v The power LED, as shown in the following figure, is slowly flashing.
v The top of the display, as shown in the following figure, shows 01 V=F .
3. Press the power button (A), as shown in the following figure, on the control panel.
v A : Power-on button
– A constant light indicates full system power to the unit.
– A flashing light indicates standby power to the unit.
– There is approximately a 30-second transition period from the time the power-on button is
pressed to when the power LED goes from flashing to solid. During the transition period, the
LED might flash faster.
A B C D E
F
G
H I
J
Front View
Top View
P8HB5500-1
Figure 24. Control panel
34
Power Systems: Installing the EMX0 PCIe Gen3 I/O expansion drawer