IBM DS3500, Инструкция по установке, эксплуатации и обслуживанию

Страница: 126 / 180

a. Push up the latch on the handle, then open the drive handle and pull the
hard disk drive assembly out of the server.
b. Pull the drive approximately 12 mm (0.5 in.) out of the bay and wait 70
seconds to allow the drive to spin down and the storage subsystem
controller to recognize that a drive is removed from the configuration.
5. Make sure that there is proper identification (such as a label) on the hard disk
drive; then, slide the drive completely out of the bay. If the drive has failed,
indicate that on the label.
6. Place the drive horizontally on a level surface.
Attention: Handle hard disk drives gently and do not stack them. Follow all
precautions for static-sensitive devices.
Installing a hard disk drive
Except during the storage subsystem initial power-on, you can add hard disk drives
while the storage subsystem is turned on and running. To install hot-swap hard disk
drives in the storage subsystem, complete the following steps.
Attention: After you remove a drive, wait 70 seconds to allow the drive to spin
down before you replace or reseat the drive. Failure to do so might cause
unpredictable results.
Note: The hard disk drive comes with a tray already attached. Do not attempt to
detach the drive from the tray.
1. Read the safety information that begins on page xiii and “Best practices
guidelines” on page 5.
2. Read the documentation that comes with the hard disk drive.
3. Remove the filler panel from the bay in which you will install the drive. Save the
filler panel for later use.
4. Unpack the new drive. Save all packing material in case you have to return the
drive.
5. (DS3512 and EXP3512) Install the hard disk drive.
Sy
stem
Sto
rag
e
Hard disk
drive status
LED (amber)
Hard disk
drive
assembly
Drive
handle
Release
latch
Hard disk
drive activity
LED (green)
Figure 87. Removing a drive from a DS3524 or EXP3524
106
System Storage DS3500 and EXP3500: Installation, User’s, and Maintenance Guide