IBM DCS3860, Инструкция по установке, использованию и обслуживанию

Страница: 44 / 204

7. Install the power supply cables to the DCS3860s. Ensure that the DCS3860
power supplies are connected to 240 V AC sources only. See “Cabling the
power supply” on page 52.
8.
Cable the DCS3860 Storage system to any storage expansion enclosures. See
Chapter 3, “Cabling the DCS3860 storage system,” on page 43.
9. Install the IBM DS Storage Manager host software to manage the DCS3860
Storage system. See “Software and hardware compatibility and upgrades” on
page 15 for the appropriate version. For instructions to install the DS Storage
Manager software, see the
IBM System Storage DS Storage Manager Version 10.8
Installation and Host Support Guide for the applicable operating system.
10. Turn on the DCS3860 (if you have not done so already). See “Powering on the
DCS3860” on page 56.
11.
Upgrade the controller firmware. See “Finding Storage Manager software,
controller firmware, and README files” on page xvi for more information.
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices and your system. To
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
v Limit your movement, so that it does not cause static electricity to build up
around you.
v
Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed printed circuitry.
v
Do not leave the device where others can handle and possibly damage the
device.
v
While the device is still in its static-protective package, touch it to an unpainted
metal part of the system unit for at least 2 seconds. This drains static electricity
from the package and from your body.
v Remove the device from its package and install it directly into your system unit
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your system unit cover or
on a metal table.
v
Take additional care when handling devices during cold weather because
heating reduces indoor humidity and increases static electricity.
Preparing for installation
Before installing the storage enclosure, create a detailed plan of how this unit will
be used in your storage configuration. The plan should include determining RAID
levels, failover requirements, operating systems to be used, and total storage
capacity requirements.
1. Prepare the site according to the area, environmental, power, and site
requirements. For more information, see “Specifications” on page 17.
2.
Move the storage enclosure to the site.
26
IBM System Storage DCS3860 Storage System: Installation, User's, and Maintenance Guide