IBM DCS3860, Инструкция по установке, использованию и обслуживанию

Страница: 102 / 204

21. If the newly inserted controller is in an offline state, see the Storage Manager
online help for instructions on bringing the controller online. If necessary,
open the Subsystem Management window and place the controller online;
select the offline controller and click
Advanced > Recovery > Place controller
online .
22. Check the state of the LEDs on the newly inserted controller. For more
information, see the "Controller LEDs" section of this document. You can also
use the Subsystem Management window to identify any new faults.
23. If any storage system has a fault (Needs Attention) status, click Recovery
Guru in the Subsystem Management window toolbar, and complete the
recovery procedure. If the problem remains, contact your IBM
technical-support representative.
24. If the storage systems have no fault, use the Storage Manager software to
print a new storage system profile.
25.
Check the WWIDs or the MAC addresses of the host ports after replacing the
controller or the host port interface adapter, or both. If you need to change
any WWID or MAC address, update the servers or switches in the
configuration.
Note: You might have to reboot your system to remove the LUNs information
that is associated with the WWID of the controller that you removed.
Removing and disposing of the system-board lithium battery
Before you begin, ensure that you wear an anti-static wrist strap.
When you disassemble the storage system for disposal, use the information in this
section to locate, remove, and dispose of the lithium batteries that are on the
system boards in controller A and controller B.
Statement 2
CAUTION:
When replacing the lithium battery, use only an equivalent type battery
recommended by the manufacturer. If your system has a module containing a
lithium battery, replace it only with the same module type made by the same
manufacturer. The battery contains lithium and can explode if not properly used,
handled, or disposed of.
Do not:
v Throw or immerse in water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose off the battery as required by local ordinances or regulations.
Complete the following steps to remove the batteries for disposal:
1. Locate the battery compartment on the system board in the controller.
84
IBM System Storage DCS3860 Storage System: Installation, User's, and Maintenance Guide