Quick installation guide
Ultrastar 2ES
SCSI
Models: DCAS-32160
DCAS-34330
IBM storage products
Page 1
IBM Hard Disk Drive Technical Support Center version 3.0
Handling precautions
1.
Do not cover the breather hole!
Covering the
breather hole may result in loss of
data.
2.
Do not press on the drive!
Do not apply any force
to the drive during handling or installation.
3. Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic
discharge (ESD).
4. Do not open the static-protective bag containing
the drive until required. Static electricity can damage
the drive.
5. Turn off and unplug your computer before
removing the case.
6. When you are installing the drive, touch the
static-protective package containing the drive to a
grounded, unpainted metal surface for at least two
seconds. (This drains static electricity from the
package and from your body.)
7. Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
8. Save your drive packaging materials including the
ESD bag in the event that the drive must be returned.
Place the drive in an anti-static bag before placing it in
the shipping container. The warranty will be void if
the drive is not returned in IBM approved packaging
.
Installation procedure
It is advisable to backup all data before proceeding
with the installation.
This procedure may require the use of a bootable
System Diskette containing FDISK.COM and
FORMAT.COM
Setting the address
1. Each drive on the SCSI bus must have a unique
address. Fifty pin (narrow SCSI) devices have 8 pos-
sible addresses with address 7 (highest priority) norm-
ally reserved for the controller. Sixty-eight pin (wide
SCSI) devices have 16 possible addresses (0-15) .
2. Jumper positions 4 (68 & 80 pin only), 3, 2, and 1
of the 12 position Option Jumper Block are used to
select the SCSI device ID. The shipping default is ID 6
(jumper positions 3 and 2).
23 (1) 24
21 (2) 22
19 (3) 20
17 (4) 18
15 (5) 16
13 (6) 14
11 (7) 12
9 (8) 10
7 (9) 8
5 (10) 6
3 (11) 4
1 (12) 2
BIT3
BIT2
BIT1
BIT0
Enable Auto Spin Up
Enable SCSI Terminator (50,68 pin)
Disable Unit Attention
Enable Auto Start Delay
Delay Start 6/12
Disable SCSI Parity Check
LED Cathod
LED Anode
Ground
Enable TI-SDTR/WDTR
Note: JP1 is reserved on the 50-pin models
