IBM Brocade, Инструкция по установке и эксплуатации

Страница: 34 / 74

22 Brocade 2-Port 10GbE Converged Network Adapter for IBM BladeCenter Installation and User’s Guide
Configuring a command session
2
13. Reinstall the cover on the blade server or storage-expansion unit. For instructions, see the
Installation and User's Guide that comes with your blade server or storage-expansion unit, and
the documentation that comes with your BladeCenter unit.
14. Reinstall the blade server in the BladeCenter unit. For instructions, see the documentation that
comes with your BladeCenter unit. Turn on the blade server, and continue with your
BladeCenter system activities.
Configuring a command session
After you install the high speed adapter, turn on the blade server; then, use the following list to
determine how to set up a command session:
•
If the blade server supports local console connection through the management-module switch
control of the keyboard/video/mouse (KVM) to the blade server, see the
Installation and User's
Guide for the blade server for instructions.
•
If the blade server does not support local console connection, see the Installation and User's
Guide for the blade server for instructions for setting up a command session with the blade
server
Removing the high speed adapter from a blade server
To remove the high speed adapter from a blade server or storage-expansion unit, complete the
following steps:
1. Read the safety information that begins on page vii and “Installation guidelines” on page 18.
2. Turn off the blade server, if you have not already done so.
3. If the blade server is installed in the BladeCenter unit, remove it (see the documentation that
comes with your BladeCenter unit for instructions).
4. Carefully place the blade server on a flat, static-protective surface.
5. Remove the cover from the blade server or storage-expansion unit. For instructions, see the
Installation and User's Guide that comes with your blade server or storage-expansion unit and
the documentation that comes with your BladeCenter unit.
Attention: To prevent damage to the connectors on the system board and the high speed
adapter, carefully perform the following steps.
6. Remove the high speed adapter, as shown in Figure 3 on page 23:
a. Rotate the handle on the high speed adapter labeled “RELEASE ONLY” to the vertical
position, while you gently pull upward on the edge of the high speed adapter near the
“Press to Install” label.
b. At an angle, slide the high speed adapter out of the mounting posts.
c. Gently lift the high speed adapter straight up and out of the blade server.