IBM BladeCenter S, Руководство по диагностике и обслуживанию, Страница: 29 / 146

Power-on
Lit (green). The advanced management module has power.
Activity
Lit (green). The advanced management module is actively controlling the
BladeCenter S system.
Error Lit (amber). An error has been detected in the advanced management
module. When the error LED is lit, the BladeCenter system error LED is
also lit.
Port Link
Lit (green). There is an active connection through the Ethernet port to the
network.
Port activity
Flashing (green). There is activity through the Ethernet port over the
network link.
Reset
Insert a straightened paper clip into the reset pinhole and remove it to restart the
advanced management module. The fan modules operate at full speed while the
advanced management module is initializing.
Attention: If you push the paper clip in all the way and hold it for approximately
10 seconds, the advanced management module will be reset to the default
configuration. Therefore, you should always make sure that you save your current
configuration before resetting the advanced management module.
For more information about saving and restoring configurations, see the IBM
BladeCenter Advanced Management Module User's Guide .
Advanced management module input and output connectors:
The advanced management module has a serial connector, a video connector, two
USB connectors for keyboard and mouse, and an Ethernet connector for remote
management.
Release handle
OK
TX/RX
LINK
Ethernet
Video
USB
Serial
Console
Chapter 1. Introduction
15