IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 71 / 216

chpasswd
Use this command to change the password for the selected user on an SAS RAID
Module. If the firmware level of your RAID controllers is older than 1.2.x.xxx, you
need to change the password on both SAS RAID Modules at the same time. If the
firmware level of your RAID controllers is 1.2.x.xxx or newer, then changing the
password on one SAS RAID Module automatically changes the password on the
other SAS RAID Module.
Command arguments:
<CLI> chpasswd -[cli | mgmtInterface ] -oldpasswd [OLDPWD] -newpasswd [NEWPWD]
-help option
Usage : chpasswd -[cli | mgmtInterface ] -oldpasswd [OLDPWD] -newpasswd [NEWPWD]
-cli : change the password for the CLI user
-mgmtInterface : change the password for the management interface
OLDPWD
: old password for the user
NEWPWD : new password for the user - it should be minimum of 8, maximum of 16 characters
There should be at least one alphabet and one numeric character in the password
Please use a combination of upper and lower case letters and numbers for the
password
clilog
The
clilog
command prints the log of all CLI commands issued and their
timestamps. If you specify the
-save
option with a filename, the log is saved to the
file.
Command arguments:
<CLI> clilog [–save file]
Where:
v file
- Names the file where the log is saved.
Example:
<CLI> clilog –save clilogfile
commparams
The
commparams
command is issued by the system administrator to set or display
the communication parameter settings. Communication is with outside agencies by
using Telnet or one or more Ethernet communication links, and the serial port
provided on the microprocessor.
Command arguments:
<CLI> commparams -[get -ctlr [0|1] -port [0|1] -ip i.j.k.l -gateway i.j.k.l
-netmask -i.j.k.l [-vlan n -vlaninsert [on|off]]]
Where:
v [0|1]
- Allows selection of the controller or port.
v i.j.k.l
- Allows selection of the IP address , gateway, or netmask.
v n
- Allows selection of the VLAN tag.
v [on|off]
- Allows selection of the VLAN tag insert.
Example:
Chapter 8. Using the RAID Controller command line interface
61