IBM BladeCenter S SAS RAID Controller Module, Инструкция по установке и эксплуатации

Страница: 34 / 216

If the firmware level of your RAID controllers is older than 1.2.x.xxx, you need to
change the password on both SAS RAID Modules at the same time. If the firmware
level of your RAID controllers is 1.2.x.xxx or newer, then changing the password
on one SAS RAID Module automatically changes the password on the other SAS
RAID Module.
Resetting the passwords on an SAS RAID Module
Before you begin
Before resetting the SAS RAID Module passwords, you must end all application
I/O processes and shut down any active Blade servers in accordance with the
recommended non-concurrent practices. Then, use the
reset to factory defaults
function within Advanced Management Module to reset the passwords.
To reset the passwords on one SAS RAID Module, you must power off both SAS
RAID Modules. Perform the following steps to reset the passwords on the SAS
RAID Module in bay 3.
Procedure
1. Stop all host I/O applications and power off the Blade servers.
2. Use the Advanced Management Module to reset the passwords.
a. Log into the Advanced Management Module.
b. Select I/O Module Tasks > Admin/Power/Restart .
c.
Select the checkboxes next to bay 3 and bay 4.
d. From the Available actions menu, select Power Off Module(s) .
e.
Click Perform action .
f. Wait until both SAS RAID Modules are powered off. The Off message will
be displayed in the Pwr column.
g. Select I/O Module Tasks > Configuration .
h. In the I/O Module Configuration section, select Bay 3 .
i. In the Bay 3 section that displays, select Advanced Configuration .
j. In the Advanced Configuration for I/O Module 3 section, select Restore
Factory Defaults .
k. Select Restore Defaults .
l.
Select
OK
.
m. The SAS RAID Module in bay 3 will power on. Wait until the SAS RAID
Module in bay 3 successfully powers on. The
On message will display in
the Pwr column, and the message POST results available: Module
completed POST successfully will display in POST Status column.
3. Power on the SAS RAID Module in bay 4.
a. Select I/O Module Tasks > Admin/Power/Restart .
b. Select the checkbox next to bay 4.
c. From the Available actions menu, select Power On Module(s) .
d. Click Perform action .
e.
The SAS RAID Module in bay 4 will power on. Wait until the SAS RAID
Module in bay 4 successfully powers on. The
On
message will be displayed
in the Pwr column, and the message POST results available: Module
completed POST successfully will display in POST Status column.
24
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module