IBM BladeCenter Management Module, Руководство по установке

Страница: 44 / 82

c. In the New Static IP address fields, specify the IP address to use for
this interface. The subnet mask must be the same as the subnet maks in
the internal network interface (eth1).
d. Click Advanced Management
→
Advanced Setup and enable the
following items:
v
I/O module external ports
v
External management for the external ports
Note: The initial user ID and password for the I/O module firmware
are:
v
User ID: USERID (all capital letters)
v
Password: PASSW0RD (note the zero, not O, in PASSW0RD)
e. Specify the IP configuration of the I/O module.
Repeat step 3 for each I/O module in the BladeCenter unit.
To communicate with the blade servers for functions such as deploying an
operating system or application program, you also will need to configure at
least one external (in-band) port on an Ethernet I/O module. See the
Installation and User’s Guide for your BladeCenter unit type for information
about configuring external ports on Ethernet I/O modules.
See the BladeCenter Management Module User’s Guide for more information about
the management-module Web interface.
Restoring a saved configuration file
If you have a saved configuration file, you can apply it to the primary or only
management module.
1.
After the primary or only management module has been installed, follow
the instructions in “Setting up the remote connection” on page 26 through
“Configuring the management module for remote access” on page 27.
2. Follow the instructions in “Starting the management and configuration
program” on page 29.
3. In the MM Control section in the navigation pane, click Configuration File
and follow the instructions under Restore MM Configuration to apply the
saved configuration file.
If a second management module is installed in the BladeCenter unit (see
“Preparing for management module redundancy” on page 9 for more
information), the new configuration information will be transferred to the
secondary management module automatically.
32
BladeCenter Management Module: Installation Guide