IBM BladeCenter JS12, Руководство по диагностике и обслуживанию

Страница: 113 / 318

Table 16. C1001F00 to C1645300 checkpoints (continued)
v
If the system hangs on a progress code, follow the suggested actions in the order in which they are listed in
the Action column until the problem is solved. If an action solves the problem, you can stop performing the
remaining actions.
v See Chapter 3, “Parts listing, Type 7998,” on page 235 to determine which components are CRUs and which
components are FRUs.
Progress code Description Action
C103A400 Special purpose registers are loaded and
instructions are started on the system
processor.
1. Go to “Checkout procedure” on page 186.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C103A401 Instructions have been started on the
system processor.
1.
Go to “Checkout procedure” on page 186.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C116C2xx System power interface is listening for
power fault events from SPCN. The last
byte (xx) will increment up from 00 to
1F every second while it waits.
1. Go to “Checkout procedure” on page 186.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C162E4xyy VPD is being collected; yy indicates the
type of device from which VPD is being
collected
1. Go to “Checkout procedure” on page 186.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C1645300 Starting a data synchronization operation
between the primary service processor
and the secondary service processor.
1. Go to “Checkout procedure” on page 186.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C2001000 to C20082FF Virtual service processor checkpoints
The C2xx progress codes indicate the progress of a partition IPL that is controlled
by the virtual service processor. The virtual service processor progress codes end
after the environment setup completes and the specific operating system code
continues the IPL.
Chapter 2. Diagnostics
99