IBM BladeCenter HT 8740, Руководство по диагностике и обслуживанию

Страница: 94 / 158

Installing a management module
To install a management module or filler, complete the following steps.
Note: These instructions assume that the BladeCenter HT unit is connected to
power.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Install a management-module interposer (see “Installing a management-module
interposer” on page 74).
3. Make sure that the release handle on the module is in the open position.
4. Slide the module into the module bay until it stops.
5. Push the release handle to the closed position.
6. Reconnect all cables to the module.
7. If this is the only management module in the BladeCenter HT unit, restore the
configuration from the configuration file that you saved when you removed the
old management module. See the
BladeCenter Management Module User’s
Guide and the BladeCenter Management Module Command-Line Interface
Reference Guide for detailed information about restoring a saved configuration
file.
8. Make sure that the OK LED on the module is lit.
9. Install the bezel that was removed during the removal procedure (see “Installing
a bezel collar” on page 45).
76
BladeCenter HT Type 8740 and 8750: Problem Determination and Service Guide