IBM BladeCenter HT 8740, Руководство по диагностике и обслуживанию

Страница: 75 / 158

Installing a power module
To install a power module or power-module filler, complete the following steps.
Note: These instructions assume that the BladeCenter HT unit is connected to
power.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Install a fan pack on the power module, if one is not installed (see “Installing a
fan pack” on page 59).
3. Make sure that the handle on the power module is in the open position.
4. Orient the new power module to the selected power-module bay:
v For the upper power-module bays, the rear connector on the power module
must be facing down.
v
For the lower power-module bays, the rear connector on the power module
must be facing up.
5. Slide the module into the bay until it stops; then, push the handle to the closed
position.
6. Install the bezel that was removed during the removal procedure (see “Installing
a bezel collar” on page 45).
Chapter 4. Removing and replacing BladeCenter HT components
57