IBM BladeCenter HT 8740, Руководство по диагностике и обслуживанию

Страница: 136 / 158

Service data
The management module stores important hardware information that can be
accessed through the management module user interface. This information is useful
for service personnel to troubleshoot problems. See the
User’s Guide that comes
with the management module for using the management module user interface to
get the service data information.
Solving undetermined problems
If the diagnostic aids did not diagnose the failure or if the BladeCenter HT unit is
inoperative, use the information in this section.
Note: When you are diagnosing a problem in the BladeCenter HT unit, you must
determine if the problem is in the BladeCenter HT unit, one of the BladeCenter
modules, or in a blade server.
v
If the BladeCenter HT unit contains more than one blade server and only one of
the blade servers has the problem, troubleshoot the blade server that has the
problem.
v
If all of the blade servers have the same symptom, it is probably a BladeCenter
HT unit or module problem.
Check the LEDs on all the power modules. If the LEDs indicate that the power
modules are working correctly, and reseating the BladeCenter components does not
correct the problem, complete the following steps to remove or disconnect the
BladeCenter components one at a time until you reach a minimal configuration or
you locate the problem.
Note: You do not have to remove power from the BladeCenter HT unit.
1. Shut down the operating system on all blade servers.
2. Make sure that each blade server is turned off; then, pull the release handles to
the open position and slide it out of the bay approximately 1 inch.
3. Disengage power modules 2, 3, and 4, one at a time. To do this, pull the
release handle to the open position and slide the power module out of its bay
approximately 1 inch.
Note: Blade servers in bays 7 through 10 will not power on with power modules
3 and 4 removed.
4. Disengage the I/O modules, one at a time. To do this, pull the release handle or
release handles to the open position and slide the I/O module out of the bay
approximately 1 inch.
Note: The following minimum configuration is required for troubleshooting the
BladeCenter HT unit. See “Features and specifications” on page 5 for the minimum
operational configuration.
v BladeCenter HT unit (media tray may be connected)
v
One power module in power module bay 1
v Four fan modules
v
One management module in management-module bay 1 or 2.
v One multiplexer expansion module in multiplexer expansion-module bay 1 or 2.
118
BladeCenter HT Type 8740 and 8750: Problem Determination and Service Guide