IBM BladeCenter HS23, Инструкция по установке и эксплуатации, Страница: 65 / 98

v
System Event Logs
Select this choice to access the System Event Manager, where you can view the
POST event log and the system-event log.
The POST event log contains the three most recent error codes and messages
that were generated during POST.
The system-event log contains POST and system management interrupt (SMI)
events and all events that are generated by the baseboard management
controller that is embedded in the integrated management module.
Important: If the system-error LED on the front of the blade server is lit but
there are no other error indications, clear the system-event log. Also, after you
complete a repair or correct an error, clear the system-event log to turn off the
system-error LED on the front of the blade server.
–
POST Event Viewer
Select this choice to enter the POST event viewer to view the UEFI diagnostic
codes.
– System Event Log
Select this choice to view the system-event log.
– Clear System Event Log
Select this choice to clear the system-event log.
v User Security
Select this choice to set, change, or clear passwords. See “Using passwords” for
more information.
v Save Settings
Select this choice to save the changes that you have made in the settings.
v
Restore Settings
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
v
Load Default Settings
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
v
Exit Setup
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.
Using passwords
Use this information to set, change, or delete a power-on password.
You can set, change, and delete a power-on password and an administrator
password in the Setup utility by selecting
System Settings then System Security .
If you set a power-on password, you must type the power-on password to
complete the system startup and to have access to the Setup Utility menu.
The password must be from 6 to 20 characters. You can use any combination of
ASCII printable characters for the password. Keep a record of your password in a
secure place.
If you forget the power-on password, you can regain access to the blade server
either by removing the blade server battery and then reinstalling it or by using the
Chapter 4. Configuring the blade server
51