IBM 9306, Руководство по техническому обслуживанию аппаратной части

Страница: 55 / 244

strain-relieving clamp.
Ground
Wire
Power
Plug
Sliding trays
Models 4QS and 4QX come with either single latch slide rails or dual latch slide
rails. Single latch slide rails have a front latch release on the right rail only. Dual
latch slide rails have a front latch release on both rails. The slide rail FRU number
for the 24-inch rack replaces the single latch slide rail with the dual latch slide rail.
Note: If a server is installed on a tray being removed, first remove the server.
Single latch rail tray
To remove a sliding tray with single latch rails:
1. Power-off the rack.
2. Open the rear door of the rack cabinet and remove the pin
1
that secures the
sliding tray to the cable management arm
3. Loosen the thumbscrews
2
on the sliding tray and fully extend the sliding tray.
4. Use a 3/32-inch allen wrench to remove the five screws
3
from the left side of
the sliding tray.
5. Lift the rear locking tab
4
and push the sliding tray approximately two inches
into the cabinet.
6. Release the forward locking tab
5
. Then, while holding the sliding tray in
place, use your other hand to grasp the outside sliding rail
6
and push it into
the rack cabinet until it disconnects from the sliding tray.
Type 9306 Models 4QS, 4QX, 9QS, 9QX, 9TS, 9TX
45