IBM 8364 E series, Руководство пользователя, Страница: 57 / 150

Using the NS Boot utility
Note: This procedure does not apply to Network Stations that have NS Boot
version H2033190 (03/31/99). You must manually update Network
Stations that have NS Boot version H2033190 (03/31/99) before you
can perform the procedures in this chapter. See “Appendix A. Updating
the NS Boot version H2033190 (03/31/99)” on page 111.
Access the NS Boot utility by performing the following procedure:
1. Power on the Network Station.
2. Enter the NS Boot utility by pressing Esc during the startup sequence.
Note: If you have enabled the password control from the IBM Network
Station Manager program, you must enter the case-sensitive
administrator password. You can specify the administrator
password through the IBM Network Station Manager program in
the Setup Tasks menu, by clicking Hardware—>Miscellaneous
Settings
.
A screen similar to the following appears:
MENU03 IBM Network Station
NS Boot Main Menu
Change language setting
Change keyboard setting
Change display settings
Configure network settings
Change boot file server settings
Change workstation configuration server settings
Change authentication server settings
Display hardware information
Display boot log
Change verbose diagnostic setting
Service aids
Use cursor keys to select task.
Enter=Continue F10=Reboot IBM Network Station
Notes:
1.
If you have not set a password in the IBM Network Station Manager
program, users can access the configuration settings in the NS Boot utility.
2. If you have set a password, users without the password can only view the
NS Boot utility, but you cannot make any configuration changes.
Chapter 8. Configuring the Network Station from the NS Boot utility
45