IBM 8248-L4T, Руководство пользователя

Страница: 68 / 214

3.
If the removed drive has a bezel attached to it, you can remove the disk drive bezel. For instructions,
see “Removing a disk drive bezel from a disk drive or filler” on page 79.
Important: If the disk drive bezel does not have a thumbscrew, then the bezel is not removable and
the drive is a SAS disk drive. The replacement SAS disk drive comes with a preinstalled bezel.
If you are installing a replacement drive as a replacement for the failed disk drive or solid-state drive, go
to “Replacing a disk drive or solid-state drive in the 8248-L4T, 8408-E8D, or 9109-RMD with the system
or logical partition power turned off” on page 70.
If you are not installing a replacement drive, install a filler in the empty slot to ensure proper air flow for
cooling. For instructions, see “Installing a disk drive filler in the 8248-L4T, 8408-E8D, or 9109-RMD” on
page 76.
Removing a solid-state drive from the EDR1 PCIe storage enclosure
Complete the following steps to remove a solid-state drive from the EDR1 PCIe storage enclosure.
1. Pull off the bezel (A) that covers the slot that contains the solid-state drive. See Figure 34 on page 53.
2. Slide the release latch (B) over gently to unlock the drive handle.
3. Grasp the handle (C) and pull the drive partially out of the slot.
Figure 33. Removing a disk drive from the system
52
Disk drives or solid-state drives