IBM 8248-L4T, Руководство пользователя

Страница: 47 / 214

6.
If the removed drive has a bezel attached to it, you can remove the disk drive bezel. For instructions,
see “Removing a disk drive bezel from a disk drive or filler” on page 79.
Important: If the disk drive bezel does not have a thumbscrew, then the bezel is not removable and
the drive is a SAS disk drive. The replacement SAS disk drive comes with a preinstalled bezel.
If you are installing a replacement drive as a replacement for the failed disk drive or solid-state drive, go
to “Replacing a disk drive or solid-state drive in the 8248-L4T, 8408-E8D, or 9109-RMD with the AIX
system or logical partition power turned on” on page 55.
If you are not installing a replacement drive, install a filler in the empty slot to ensure proper air flow for
cooling. For instructions, see “Installing a disk drive filler in the 8248-L4T, 8408-E8D, or 9109-RMD” on
page 76.
Removing a solid-state drive from the EDR1 PCIe storage enclosure
Complete the following steps to remove a solid-state drive from the EDR1 PCIe storage enclosure.
1. Select Replace/Remove a Device Attached to an SCSI Hot Swap Enclosure Device .
2. Select the solid-state drive that you want to remove. To view the locations of the service indicators, go
to “Solid-state drive locations and service indicators for the EDR1 PCIe storage enclosure” on page 95.
3. Press Enter.
4. Pull off the bezel (A) that covers the slot that contains the solid-state drive.
5. When the solid-state drive identify LED turns on solid, slide the release latch (B) over gently to
unlock the drive handle. See Figure 18 on page 32.
6.
Grasp the handle (C) and pull the drive partially out of the slot.
7. Grasp the solid-state drive and pull it out from the slot.
8.
Press Enter on the console to indicate that you have removed the solid-state drive.
Figure 17. Removing a disk drive from the system
Removing a disk drive or solid-state
31