IBM 8038, Инструкция по установке и эксплуатации

Страница: 79 / 104

6. When you are prompted with the question, "What do you want the wizard to
do?", select
Install from a list or specific location (Advanced) . Click Next to
continue.
7.
When you are prompted with the statement, "Please choose your search and
installation options", select
Don't search. I will choose the driver to install .
Click Next to continue.
8. When you are prompted with the statement, "Select a hardware type, and
then click Next", select
Network adapters . Click Next to continue.
9. You are prompted with the statement, "Completing the Found New Hardware
Wizard". Click
Finish .
Note: A new local area connection appears and might state, "This connection
has limited or no connectivity". Ignore this message.
10.
Go back to the Device Manager. IBM USB Remote NDIS Network Device
appears under Network Adapters .
11. Open a command prompt, type
ipconfig
, and press Enter. The local area
connection for the IBM USB RNDIS appears with an IP address in the range of
169.254.
xxx.xxx with a subnet mask set to 255.255.0.0.
LAN over USB Linux Driver Installation
Use this information to install the LAN over USB driver for Linux.
Current versions of Linux, such as RHEL5 Update 2 and SLES10 Service Pack 2,
support the LAN over USB interface by default. This interface is detected and
displayed during the installation of these operating systems. When you configure
the device, use a static IP address of 169.254.95.130 with a subnet mask of
255.255.0.0.
Note: Older Linux distributions might not detect the LAN over USB interface, and
might require manual configuration. For information about configuring LAN over
USB on specific Linux distributions, see http://www-947.ibm.com/support/entry/
portal/docdisplay?brand=5000008&lndocid=MIGR-5083207 .
The IMM LAN over USB interface requires that the usbnet and cdc_ether drivers
be loaded. If the drivers have not been installed, use modprobe to install them.
When these drivers are loaded, the IMM USB network interface shows up as a
network device in the operating system. To discover the name that the operating
system has assigned to the IMM USB network interface, type:
dmesg | grep -i cdc ether
The interface is configured with
ifconfig
to have an IP address in the range
169.254. xxx.xxx . For example:
ifconfig IMM_device_name 169.254.1.102 netmask 255.255.0.0
This interface is configured to come up with an IP address in the 169.254. xxx.xxx
range each time that the operating system is booted.
Chapter 4. Configuring the blade server
65