While the server is turned off, move switch 1 of the switch block (SW4) to the On position to enable the
power-on password override. You can then start the Setup utility and reset the power-on password. You
do not have to return the switch to the previous position.
The power-on password override switch does not affect the administrator password.
Administrator password
If an administrator password is set, you must type the administrator password for access to the full Setup
utility menu. You can use any combination of 6 to 20 printable ASCII characters for the password.
Attention:
If you set an administrator password and then forget it, there is no way to change, override, or
remove it. You must replace the system board.
Using the Boot Manager program
The Boot Manager program is a built-in, menu-driven configuration utility program that you can use to
temporarily redefine the first startup device without changing settings in the Setup utility.
To use the Boot Manager program, complete the following steps:
Step 1. Turn off the server.
Step 2. Restart the server.
Step 3. When the prompt
<F12> Select Boot Device
is displayed, press F12. If a bootable USB mass
storage device is installed, a submenu item (
USB Key/Disk
) is displayed.
Step 4. Use the Up arrow and Down arrow keys to select an item from the
Boot Selection Menu
and press
Enter.
The next time the server starts, it returns to the startup sequence that is set in the Setup utility.
Starting the backup server firmware
The system board contains a backup copy area for the server firmware. This is a secondary copy of the
server firmware that you update only during the process of updating the server firmware. If the primary copy
of the server firmware becomes damaged, use this backup copy.
The system board contains a backup copy area for the server firmware (formerly BIOS firmware). This is a
secondary copy of the server firmware that you update only during the process of updating the server
firmware. If the primary copy of the server firmware becomes damaged, use this backup copy.
To force the server to start from the backup copy of the server firmware, turn off the server; then, place the
J29 jumper in the backup position (pins 2 and 3).
Use the backup copy of the server firmware until the primary copy is restored. After the primary copy is
restored, turn off the server; then, move the J29 jumper back to the primary position (pins 1 and 2).
Using the ServerGuide Setup and Installation CD
Use this information as an overview for using the ServerGuide Setup and Installation CD.
The
ServerGuide Setup and Installation
CD provides software setup tools and installation tools that are
designed for your server. The ServerGuide program detects the server model and hardware options that are
installed and uses that information during setup to configure the hardware. The ServerGuide program
simplifies operating-system installations by providing updated device drivers and, in some cases, installing
111
Содержание 7944
