IBM 7383, Инструкция по установке и обслуживанию, Страница: 77 / 488

4. Remove the fan cage assembly (see “Removing the fan cage assembly” on
page 304).
5.
Remove the EMC shields from the drive bay, if installed.
6. Touch the static-protective package that contains the tape drive to any
unpainted metal surface on the server; then, remove the tape drive from the
package.
7. Install the blue rails on the tape drive.
8. Follow the instructions that come with the drive to set jumpers or switches, if
there is any.
Note:
You might find it easier to install the new drive from the front and then
attach the cables.
9. Align the rails on the tape drive with the guides in the drive bay; then, slide
the tape drive into the drive bay until the rails click into place.
10.
Connect the power and signal cables to the drive and the connectors on the
system board (see “Internal cable routing and connectors” on page 186 for
more information).
What to do next
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 94.
Memory module installation
The following notes describe the types of DIMMs that the server supports and
other information that you must consider when you install DIMMs.
v
When you install or remove DIMMs, the server configuration information
changes. When you restart the server, the system displays a message that
indicates that the memory configuration has changed.
v
The server supports only industry-standard double-data-rate 3 (DDR3), 800,
1066, 1333, or 1600 MHz, PC3-6400, PC3-8500, PC3-10600, or PC3-12800
registered or unbuffered, synchronous dynamic random-access memory
(SDRAM) dual inline memory modules (DIMMs) with error correcting code
(ECC). See http://www.ibm.com/systems/info/x86servers/serverproven/
compat/us for a list of supported memory modules for the server.
– The specifications of a DDR3 DIMM are on a label on the DIMM, in the
following format.
– ggggg eRxff PC3 v - wwwwwm - aa - bb - ccd
Chapter 2. Installing optional devices
59