IBM 7378, Руководство по диагностике и обслуживанию

Страница: 281 / 362

Installing the simple-swap backplate
To install the simple-swap backplate, complete the following steps.
1. Insert the bottom tabs of the replacement simple-swap backplate onto the slots
on the lower lip of the drive cage.
2. Rotate the simple-swap backplate toward the drive cage (make sure to align it
with the locator pin) until it locks in place in the retaining tabs of the
spring-release latch on the drive cage.
3. Reconnect the power, configuration, and signal cables to the 3.5-inch hard disk
drive backplate. For more information, see Internal cable routing and
connectors.
4. Install the simple-swap hard disk drives that were removed from the hard disk
drive cage (see “Installing a simple-swap hard disk drive” on page 196).
5. Install the fan cage assembly (see “Installing the fan cage assembly” on page
244).
6. Install the air baffle (see “Installing the air baffle” on page 213).
7. Rotate the power-supply cage assembly back into the server. Press the
power-supply cage release tab and rotate the power-supply cage assembly
into the chassis.
Chapter 5. Removing and replacing server components
263