IBM 7163, Руководство по диагностике и обслуживанию

Страница: 59 / 210

3. If necessary, remove the adapter guide before you install a full-length adapter.
4. Press the adapter firmly into the adapter connector.
5. Replace the adapter retention bar to stabilize the adapter.
6. Close the adapter retention latch. Be sure to align the pin on the latch with the
matching hole in the chassis.
7. Connect any required cables to the adapter.
8. Install the top cover (see “Replacing the top cover” on page 42).
9. Connect the cables and power cords (see “Connecting the cables” on page 40
for cabling instructions).
10. Turn on all attached devices and the server.
Removing the adapter retention bar
To remove the adapter retention bar, complete the following steps.
Front adapter
retention bracket
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Remove the top cover (see “Removing the top cover” on page 41).
4. Remove the adapters (see “Removing an adapter” on page 42).
5. Lift open the adapter retention bar.
6. Press the sides of the adapter retention bar and lift it out of the server.
7. If you are instructed to return the adapter retention bar, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Replacing the adapter retention bar
To install the replacement adapter retention bar, complete the following steps:
1. Press the sides of the adapter retention bar and install it.
2. Install the adapters (see “Replacing the adapter” on page 42).
3. Install the top cover (see “Replacing the top cover” on page 42).
4. Connect the cables and power cords (see “Connecting the cables” on page 40
for cabling instructions).
5. Turn on all attached devices and the server.
Chapter 4. Removing and replacing server components
43