IBM 7163, Руководство по диагностике и обслуживанию

Страница: 139 / 210

In the error codes, x can be any numeral or letter. However, if the three-digit
number in the central position of the code is 000, 195, or 197,
do not replace a
CRU or FRU. When these numbers are in the central position of the code, they
have the following meanings:
000 The server passed the test. Do not replace a CRU or FRU.
195 The Esc key was pressed to end the test. Do not replace a CRU or FRU.
197 This is a warning error, but it does not indicate a hardware failure; do not
replace a CRU or FRU. Take the action that is indicated in the Action
column but
do not replace a CRU or a FRU . See the description of
Warning in “Diagnostic text messages” on page 122 for more information.
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, “Parts listing, System x3755 Type 8877 and 7163,” on page 25 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
001-197-000 Test aborted.
1. Check the system-error log and the BMC log for
messages that indicate the cause of the error,
and take the indicated action.
2. From the diagnostic programs, run Quick Memory
Test All Banks; then, if an error is detected, take
the indicated action.
3. Reinstall and if necessary, update the BIOS code
on the server; then, rerun the test (see “Updating
the firmware” on page 13).
001-198-000 Test aborted.
1. Check the system-error log and the BMC log for
messages that indicate the cause of the error,
and take the indicated action.
2. From the diagnostic programs, run Quick Memory
Test All Banks; then, if an error is detected, take
the indicated action.
3. Reinstall and if necessary, update the BIOS code
on the server; then, rerun the test (see “Updating
the firmware” on page 13).
001-250-00n ECC Test logic failed, where n = failing
microprocessor [1 - 4].
1. Restart the server.
2. From the diagnostic programs, run the ECC test
again; then, if an error is detected, take the
indicated action.
3. Reseat the microprocessor/memory card. See
“Removing a microprocessor/memory card” on
page 51 and “Replacing a microprocessor/
memory card” on page 51.
4. Replace the microprocessor/memory card. See
“Removing a microprocessor/memory card” on
page 51 and “Replacing a microprocessor/
memory card” on page 51.
Chapter 5. Diagnostics
123