IBM 7063-CR2, Руководство пользователя

Страница: 117 / 134

Figure 128. Removing the front screws
6. From the rear of the system, push the system forwards approximately 5 cm (2 in).
7. From the front of the system, while you support the system from underneath, slide the system out of
the rack.
Be careful when removing the system. The rails have no intermediate stopping point. Be sure to
support the system from underneath.
8. Carefully set the system on a table with an appropriate ESD surface.
Placing a 7063-CR2 system into the operating position
To place an IBM Power Systems HMC (7063-CR2) system into the operating position, complete the steps
in this procedure.
About this task
CAUTION: This part or unit is heavy but has a weight smaller than 18 kg (39.7 lb). Use care when
lifting, removing, or installing this part or unit. (C008)
Procedure
1. Lift the system from the table.
2. Align the rails on each side of the system with the rack slide rails.
3. Push the system into the rack.
4. Fasten the two front screws to secure the system to the rack.
Figure 129. Replacing the front screws
5. If you removed the two power supplies, replace them.
For instructions, see “Replacing a power supply in the 7063-CR2 system” on page 52.
6. If you removed the system backplane, replace it.
a) Ensure that the two system backplane levers are open.
b) Support the system backplane by the bottom as you position the system backplane and insert it
into the system until it is fully seated.
Important:
Common procedures for servicing the 7063-CR2 103