Rack Mount Guide for IBM
PN 68Y9708/60Y0328
Installing the appliance in a rack
The slide rails are for a 19 inch (48.26 centimeter) rack. The appliance ships with a slide rail kit and a
shipping bracket kit. The contents of the slide rail kit are required to install the appliance. You can use
the shipping bracket kit if you plan to transport the rack cabinet to another location. If any of the
following parts are not included in your shipment, contact your place of purchase.
The slide rail kit includes the following parts:
v
Two slide rails
v
Four screws (M6) to secure the brackets to the appliance
v
Two screws (10-32)
The shipping bracket kit includes the following parts:
v
Two-shipping brackets (left and right)
v
Four cage nuts
v
Four clip nuts
v
Four screws (M6)
Supported appliances
The following table lists the appliance models that are supported by the instructions in this document:
Product
Model
IBM
®
Part Number
IBM Security Access Manager
AMP 5100
97Y0608
IBM Security Network Protection
XGS 3100
97Y0977
XGS 4100
97Y0823
XGS 5000
97Y0680
XGS 5100
97Y0612
XGS 7100
97Y1013
IBM Security SiteProtector
™
System
SP 3001
46N5744
SP 4001
97Y1346
Installing the slide rails in the rack frame
Note:
If the slide rails in your rack installation kit came with shipping thumbscrews, remove them before
you start installing the appliance.
Complete the following steps to install the slide rails in the rack frame:
1.
Open the front slide rail latches, as shown in Figure 1 on page 2.
a.
Notice that each slide rail is marked with either an
R
(right) or an
L
(left).
b.
Select one of the slide rails and push up on the front moveable tab
1
; then, pull out the front
latch
2
.
c.
If a thumbscrew is installed in the slide rail
3
, remove the thumbscrew.
