IBM 64-bit/66MHz PCI ATM MMF, Инструкция по установке и использованию

Страница: 20 / 40

7. If you need to make changes, continue with the next step; otherwise, press F10 to
exit SMITTY.
8. From the PVCs for IP over an ATM Network menu, select Change / Show
Characteristics of a PVC for IP over an ATM Network .
9. From the list of Available Interfaces, select at0 .
10. If necessary, change values in the Change / Show Characteristics of a PVC for IP
over an ATM Network screen, and press Enter.
11. When the Command status in the Command Status screen changes from
running
to OK
, press F10 to exit SMITTY.
Removing the ATM 155 Software
To remove the ATM 155 software, do the following:
1. Log in to the AIX operating system as root user.
2. At the AIX command prompt, type:
smitty inet
and press Enter.
3. From the Network Interface Selection menu, select Remove a Network Interface .
4. From the Available Network Interfaces list, select at0 .
5. When the Command status in the Command Status screen changes from
running
to OK
, press F10 to exit SMITTY.
6. At the AIX command prompt, type:
smitty atm_adpt
and press Enter.
7. From the Adapter menu, select Remove an ATM Adapter .
8. From the ATM Adapter list, select at0 .
9. In the Remove an ATM Adapter screen, set KEEP definition in database to no, and
press Enter.
10. When removal is complete and the Command status changes from
running
to
OK
,
press F10 to exit SMITTY.
11. At the AIX command prompt, type:
smitty install
and press Enter.
12. From the Software Installation and Maintenance menu, select Maintain Installed
Software .
13. From the Maintain Installed Software menu, select Remove Software Products .
14. In the Remove Software Products screen:
v
Type the SOFTWARE name,
devices.pci.14106001
v
To PREVIEW only, select no.
v
To REMOVE dependent software, select yes.
10
Installation and Using Guide