IBM 5887, Установка

Страница: 37 / 96

v
Your system is managed by an IBM Hardware Management Console (HMC).
v
Your system is not managed by an HMC, but has only one partition, and that partition is running
the IBM i operating system.
Note: If you do not have one of these configurations, you must power off the system to add
enclosures.
Removing the shipping bracket on a preinstalled enclosure
Learn how to remove the shipping bracket that is used to brace the preinstalled enclosure.
There are three parts in the bracket assembly that is used to stabilize the 5887 disk drive enclosure during
shipment of the rack that contains the enclosure. The bracket assembly consists of a large bracket that
attaches to the rack frame and two smaller brackets that secure the two enclosure services manager (ESM)
units.
Prerequisite: A medium size screwdriver is required to complete this task.
To remove the shipping bracket, complete the following steps:
1. Attach the electrostatic discharge (ESD) wrist strap.
Attention:
v
Attach an electrostatic discharge (ESD) wrist strap to an unpainted metal surface of your hardware
to prevent the electrostatic discharge from damaging your hardware.
v
When using an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is used
for static control. It does not increase or decrease your risk of receiving electric shock when using
or working on electrical equipment.
v
If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
2. To clear the shipping bracket installation area of cables and cords, complete the following steps:
a. Find the slotted opening in the small front bracket (A) below the left enclosure services manager
(ESM) and loosen the power supply cord (B) that is visible in the opening.
b. Carefully pull up the power supply cord through the small front bracket opening.
c. After you remove the connector end of the power cord from the opening (C) , hang the loose
length of cable to one side so that it does not interfere with your workspace in the shipping
bracket installation area.
d. Using the same technique, remove and hang the right power supply cord. Do not disconnect or
detach the power supply cords from their attachments to the rack or to other cables.
Installing the 5887 disk drive enclosure or setting up a preinstalled 5887 disk drive enclosure
23