IBM 5147-024, Руководство пользователя

Страница: 40 / 64

7. If you powered down either the system or the partition before you connected the storage enclosure
cables to it, power on the system or partition. If you did not power down the system or partition,
depending on the option you chose in the beginning of this procedure, you might need to reconfigure
the adapters.
Completing the 5147-024, ESLL, or ESLS storage enclosure installation
Learn how to complete the installation process.
To complete the installation process, complete the following steps:
1. To learn how to add the disk drives to the operating system, see the following information:
v To configure a disk drive or SSD for use by AIX, see Configuring a disk drive or solid-state drive
for use in an AIX system or AIX logical partition (http://www.ibm.com/support/
knowledgecenter/POWER8/p8hal/pxhal_configdrive_aix.htm).
v
To configure a disk drive or SSD for use by IBM i, see Configuring a disk drive or solid-state drive
for use in an IBM i system or IBM i logical partition (http://www.ibm.com/support/
knowledgecenter/POWER8/p8hal/pxhal_configdrive_ibmi.htm).
v To configure a disk drive or SSD for use by Linux, see Configuring a disk drive or solid-state drive
for use in an Linux system or Linux logical partition (http://www.ibm.com/support/
knowledgecenter/POWER8/p8hal/pxhal_configdrive_linux.htm).
2. To verify that the system or logical partition recognizes the disk drive enclosure, see Verifying the
installed part (http://www.ibm.com/support/knowledgecenter/POWER8/p8haj/
pxhaj_hsmverify.htm).
3. You have completed the steps to install the 5147-024, ESLL, or ESLS storage enclosure. If you were
directed here from another procedure, return to that procedure now.
24
Power Systems: Installing the Model 024, ESLL, or ESLS storage enclosure