5.
Rotate the handle (A) to the locked position.
6.
If you are installing more than one drive, repeat the steps in this procedure until all drives are
installed.
7.
Review the following information that is related to connecting this device:
The ESLL storage enclosure can hold up to 12 large form factor disk drives. The 5147-024 and ESLS
storage enclosures can hold up to 24 small form factor drives. The storage enclosures can be split
logically into one, two, or four independent groups.
The 5147-024, ESLL, or ESLS storage enclosure support the following operating systems:
v
AIX
®
(The 5147-024 storage enclosure is not supported by AIX.)
v
IBM i (The 5147-024 and ESLL storage enclosures are not supported by IBM i.)
v
Linux
v
VIOS (The 5147-024 storage enclosure is not supported by VIOS.)
If you are planning to configure RAID arrays, ensure that you have the minimum number of available
disks for each RAID level:
RAID 0
Minimum of one drive per array.
RAID 5
Minimum of three drives per array.
RAID 6
Minimum of four drives per array.
RAID 10
Minimum of two drives per array.
Connecting the 5147-024, ESLL, or ESLS storage enclosure to your
system
Learn how to connect the 5147-024, ESLL, or ESLS storage enclosure to your system.
Note:
The cables that are used to connect the 5147-024, ESLL, or ESLS storage enclosure to a server are
different from the cables that are used with the 5887 disk drive enclosure.
To connect the 5147-024, ESLL, or ESLS storage enclosure to a system with support for a serial-attached
SCSI (SAS) storage enclosure, complete the following steps.
For more information about SAS cabling and cabling configurations, see Serial-attached SCSI cable
planning (http://www.ibm.com/support/knowledgecenter/POWER8/p8had/p8had_sascabling.htm).
1.
Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2.
Confirm the factory-set mode of the enclosure by using information that is printed on stickers at the
rear of the enclosure. Stickers are attached to the lower-left shelf of the chassis (A) and the center
support between the enclosure services manager modules (B). The stickers indicate whether the
enclosure is set to mode 1, mode 2, or mode 4. For more information, see Figure 12 on page 12.
Note:
The 5147-024 storage enclosure only supports mode 1.
Installing the Model 024, ESLL, or ESLS storage enclosure
11
Содержание 5147-024
