IBM 4764, Руководство по установке

Страница: 21 / 34

Table 2. Jumpers on the PCI-X cryptographic coprocessor
Jumper Number of
pins
Name of jumper Position when shipped
J7 2 PCI-X EEPROM write Shipped with jumper installed
J8 2 External intrusion latch disable Shipped with jumper installed
J9 2 Battery disconnect wire Shipped with jumper (wire loop) installed
J10 3 (keyed) Temporary-battery connector Shipped without jumper installed
J11 5 External intrusion latch Shipped with jumper installed
Note: Shipped with jumper installed means that the pins are connected.
9. Insert the coprocessor into the slot; be sure the card is fully seated.
10. If you removed a cover from the expansion slots, replace it.
11. Replace the host computer’s cover.
12. Reconnect the power cable and any other cables you disconnected.
13. Turn the computer ON. The PCI-X cryptographic coprocessor runs its power-on self-test (POST).
You have completed the procedure for the physical installation of the PCI-X cryptographic coprocessor.
Refer to the support software documentation for information about initializing and using the coprocessor.
R
S
2
3
2
Eth
net
Back Side
J11
Figure 2. Jumpers on the PCI-X cryptographic coprocessor (back side)
Chapter 2. Installing the coprocessor
5
||||
||||