IBM 4247 Model 003, Руководство пользователя

Страница: 123 / 392

Enabled
Allows the operator panel selection for paper source to override host data
stream commands for paper source selection.
To change or check the Override Host / Paper Source selection, follow these steps:
1. Press Menu.
2. Press Scroll
↑
or Scroll
↓
until the printer displays
CONFIGURATION MENU
Coax Configuration
3.
Press Enter.
4. Press Scroll
↑
or Scroll
↓
until the printer displays
Coax Configuration
Override Host
5. Press Enter and the printer displays
Override Host
Paper Source
6.
Press Enter to display the current value.
7. Press Scroll
↑
or Scroll
↓
until the desired value for Override Host / Paper
Source is displayed.
8.
Press Enter. An asterisk (*) will be displayed in front of the selected value.
9. Press Start or Return to exit the Menu.
Using Programmed Symbols (PS) Parameters
You can only define the following parameters if the Programmed Symbols (PS)
parameter in the Printer Compatibility category is set to
Enabled
. See
“Programmed Symbols” on page 109.
You can define the following PS Parameters:
v
Plane Selection
v
Full Page On Skip Suppress
v
PS Print Direction
Plane Selection
You can set the Plane Selection to:
v
3 1 Triple (Default)
v
6 Single.
Note: The printer performs a partial reset to put any change to this parameter
value into effect when you exit the Configuration Menu with Start or
Return
. Buffered data will be lost.
To change or check the plane selection, follow these steps:
1. Press Menu.
Chapter 8. Coax Configuration
113