IBM 4002-C2A, Инструкция по установке и эксплуатации

Страница: 77 / 98

Syntax: show version
The highlighted lines in the output indicate the versions currently running boot,
monitor and Multi-Service IronWare images for the switches. The fields are
described in Table 12 on page 49 except for the following:
The “HW:” line indicates the hardware and the type of software package enabled
on the unit. The type of software package enabled on the system can be one of the
following:
v
BASE: Indicates that the BASE software package is enabled on the unit.
v
ME_PREM: Indicates that the ME_PREM premium package is enabled on the
unit.
v L3_PREM: Indicates that the L3_PREM premium package is enabled on the unit.
For a detailed description of the features available in each type of software
package, please refer to the
Configuration Guide .
Backing up the current software images
Before performing a software upgrade, IBM strongly recommends backing up the
following current software images in the device’s flash memory.
Syntax: cp <original-file-name> <backup-file-name>
Virtual interface module
The switches feature a virtual interface module. These commands open an rconsole
session with the virtual interface module in virtual slot 1, enter the Privileged
EXEC level of the interface module’s CLI, and make a backup copy of the monitor
file. Entering the two exit commands returns you to the Privileged EXEC level of
the CLI.
NetIron#rconsole 1
Remote connection to LP slot 1 established
Press CTRL-X or type 'exit' to disconnect it
LP-1>en
No password has been assigned yet...
LP-1#
#
Syntax: rconsole <slot-number>
The <slot-number> parameter specifies the chassis slot number of the virtual
interface module to which you want to open an rconsole session. For the c-series
switches switches, this should always be 1.
Syntax: enable
Syntax: exit
Syntax: Ctrl-X
Upgrading the multi-service IronWare image
To upgrade the c-series switches Multi-Service IronWare image (primary or
secondary), you must perform the following steps:
Chapter 7. Upgrading software images and configuration files
51