IBM 2-Gigabit Fibre Channel PCI, Инструкция по установке и использованию

Страница: 11 / 52

Chapter 1. Overview
Use a Gigabit Fibre Channel PCI Adapter (Type 4-S) to make high-speed connections
between stand-alone system units and storage servers on a fibre channel network at
speeds up to a Gigabit per second. This adapter requires a PCI 2.1, 32-bit, 33 MHz
slot.
Use a 2-Gigabit Fibre Channel PCI Adapter (Type 4-W) to make high-speed
connections between stand-alone system units and storage servers on a fibre channel
network at speeds up to two gigabits per second. This adapter requires a PCI 2.2,
64-bit, 66 MHz slot.
Adapter Features
Gigabit Fibre Channel PCI Adapter (Type 4-S)
v
1062Mb/s Fibre Channel Interface
v
PCI Bus Compatible (32-bit slot)
v
Supports Short Wave Optics (non-OFC)
v
Upgradable microcode (See your System User’s Guide or contact your service
representative)
1. Multimode Fiber SC Connector
2. Data Link Status LEDs
3. Jumper JX1, Pins 1 to 2 only
1