3.
Align the back-alignment pins of the rail with the holes at the back of the rack. The holes are
identified by the self-adhesive placement dots on the back of the rack. Ensure that the rails are level.
4.
Slide the release tab
(B)
to extend the two back-alignment pins into the back of the rack. Ensure that
the pins have passed through the correct holes in the rack frame.
5.
From the back of the rack, as shown in Figure 23 on page 31, install the rail support bracket on the
alignment pins. Then insert a large rail-retaining screw into the hole located between the two back
alignment pins. Partially tighten the screw. Do not tighten completely at this time.
Note:
The brackets are labeled LEFT and RIGHT. In the following illustration, these brackets are
shown in blue for emphasis.
Figure 22. Front slide rail alignment pin, retaining screws, and latch bracket
30
Installing into a rack
Содержание 0551
