• For support details, see the Linux Alert website (http://www14.software.ibm.com/webapp/set2/sas/f/
lopdiags/info/LinuxAlerts.html).
PCIe3 2-port 10 GbE NIC & RoCE SFP+ copper adapter (FC EC37, FC EC38, FC EL3X, and FC EL53;
CCIN 57BC)
Learn about the specifications and operating system requirements for the feature code (FC) EC37, FC
EC38, FC EL3X, and FC EL53 adapters.
Overview
The FC EC37 and FC EL3X are low-profile adapters, and the FC EC38 and FC EL53 are full-height
adapters.
The PCIe3 2-Port 10 GbE NIC & RoCE SFP+ adapter is a PCIe generation-3 (PCIe3), dual port, 10 Gigabit
Ethernet (GbE) adapter with a PCIe 3.0 host bus interface. The adapter provides two 10 Gb SFP+ ports for
copper twinax cabling. These cables also include copper transceivers. The adapter is a converged
network adapter supporting both NIC and IBTA RoCE standard. RoCE is Remote Direct Memory Access
(RDMA) over Converged Ethernet. Using RoCE, the adapter can support significantly greater bandwidth
with low latency and minimize CPU overhead by more efficiently using memory access. This offloads the
CPU from I/O networking tasks, improving performance and scalability.
Active Copper twinax cables up to 5 meter in length are supported such as provided by FCs EN01, EN02
or EN03. A copper transceiver is included with these cables. See “Cables” on page 89 for details. Each
10 Gb port provides Ethernet connectivity with a nominal data rate of 10 Gbps (gigabits per second).
The adapter provides the following features:
• The adapter is a PCIe3 NIC network convergence adapter.
• The adapter supports RoCE and NIC functions but not concurrently on same adapter.
• The adapter supports the following standards for the different ports and functions:
– AIX NIM and Linux Network Install are supported
– IBTA RoCE v2 support
– IEEE 802.3ae in the 10 GbE ports
– 802.3ab in the 1 GbE ports
– Ether II and IEEE 802.3 for encapsulated frames
– 802.1p for setting up priority levels in tagged VLAN frames
– 802.1Q for VLAN tagging
– 802.3x for flow control
– 802.3ad for load-balancing and failover
– IEEE 802.3ad and 802.3 for link aggregation
• The adapter provides message signal interrupts (MSI), MSI-X, and support of legacy pin interrupts.
• The adapter supports jumbo frames up to 9.6 KB.
• The adapter supports gigabit EtherChannel (GEC) with the existing software.
• The adapter supports TCP checksum offload transmission control protocol (TCP), user datagram
protocol (UDP), TCP segmentation Offload (TSO) for IPv4 and IPv6.
• Supports TCP segmentation or large send offload
• Supports EEPROM-SPI and single EEPROM
• Compliant with European Union Directive 2002/95/EC on the Restriction of the Use of Certain
Hazardous Substances in Electrical and Electronic Equipment
86 Power Systems: Managing PCIe adapters
Содержание 00E2714
