ibidi 12150, Инструкция по эксплуатации

Страница: 11 / 36

ibidi Heating System Multiwell Plate – Silver Line
• The heated glass plates of the incubation chamber can break on mechanical impact. If so, the
glass shards can lead to injuries if handled.
• Be aware that when switched on, a 10 V DC voltage is applied to the underside of the glass
on the Heated Lid. Do not touch the underside or put it in contact with anything conductive.
This could cause a short circuit that may damage the ibidi Temperature Controller – Silver Line
and/or the Heated Devices (e.g., Heated Plate, Heated Lid of Incubation Chambers).
1.7 Limited Warranty
Products manufactured by ibidi, unless otherwise specified, are warrantied for a period of one year
from the date of shipment to be free of defects in materials and workmanship. If any defects in the
product are found during this warranty period, ibidi will repair or replace the defective part(s) or
product free of charge.
This warranty does not apply to defects resulting from the following:
1. Improper or inadequate installation.
2. Improper or inadequate operation, maintenance, adjustment, or calibration.
3. Unauthorized modification or misuse.
4. Use of unauthorized tubing or fluidic connectors.
5. Use of consumables, disposables, and parts not supplied by an authorized ibidi distributor.
6. Corrosion due to the use of improper solvents, samples, or due to surrounding gases.
7. Accidents beyond ibidi’s control, including natural disasters.
This warranty does not cover consumables, such as cell culture chambers and dishes, tubes, fluidic
connectors, reagents etc.
The warranty for all parts supplied and repairs provided under this warranty expires on the warranty
expiration date of the original product.
1.8 Transporting the ibidi Heating System Multiwell Plate
The weight of the ibidi Temperature Controller – Silver Line is approx. 1.75 kg/3.86 lbs. Moving
the ibidi Temperature Controller – Silver Line during operation can pose a risk of personal injury or
damage to the instrument.
For transport, switch off the ibidi Temperature Controller – Silver Line and then disconnect the heated
components from the controller. Carry the devices carefully and avoid mechanical shocks.
WARNING – Hot surface (max. 55°C)! Do not touch Heated Lid and Heated Plate
when hot. Always disconnect the instrument from the power supply before transport
and leave the instrument to cool down for approx. 5 minutes.
Instruction Manual 11 Version 1.0 (August 1, 2022)