Manual
ibaBM-DP
86
Issue 1.7
10.3.6.3 „Digital“ tab
On the “Digital” tab, you find two predefined diagnostic values:
Slave is in exchange mode
Shows that a slave is in exchange mode, thus sends and receives Data Exchange
Telegrams. This is the normal state.
Currently active bus (for redundant slaves)
When the redundancy mode is activated (see chapter 12), the active bus for the
slave that is being analyzed is shown here.(0: Bus0,1: Bus1).
Fig. 54: „Slave diagnostics“ module– „Digital“ tab
10.3.7 „Bus diagnostics“ module
With the “Bus diagnostics” module, you can acquire predefined diagnostic signals for
both busses 0/1 of ibaBM-DP in ibaPDA.
Important note
The “Bus diagnostics” module requires firmware v01.04.001 or more recent and ibaPDA
v6.37.0 or higher. You can use the module only in 32Mbit Flex mode. In compatibility
mode 32Mbit, the module remains disabled in the I/O Manager.
10.3.7.1 „General“ tab
Fig. 55: „Bus diagnostics“ module – „General“ tab
