
1/16, 1/8, 1/4, ½, 1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22,
30
60 Hz (NTSC)
CIF (352x240)
1/16, 1/8, 1/4, ½, 1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22,
25
50 Hz (PAL)
CIF (352x288)
1/16, 1/8, 1/4, ½, 1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22,
30
60 Hz (NTSC)
2CIF (704x240)
1/16, 1/8, 1/4, ½, 1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22,
25
50 Hz (PAL)
2CIF (704x288)
1/16, 1/8, 1/4, ½, 1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22,
30
60 Hz (NTSC)
D1 (704x480)
1/16, 1/8, 1/4, ½, 1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22,
25
50 Hz (PAL)
D1 (704x576)
1, 2, 4, 6, 8, 10, 12, 15
60 Hz (NTSC)
1280x720
1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22, 25
50 Hz (PAL)
1280x720
1, 2, 4, 6, 8, 10
60 Hz (NTSC)
1600x1200
1, 2, 4, 6, 8, 10, 12
50 Hz (PAL)
1600x1200
Tip
½ fps means that 1 frame will be recorded
every 2 seconds, 1/4 - 1 frame every 4
seconds, etc.Frame rates less or equal to 4
frames-per-second are recommended when
recording at 1600x1200 resolution.
7. From the
BitRate
drop-down menu select the maximum transmission bit rate. Note that higher image resolutions
require higher bit rate. Use the table below to determine the recommended maximum bit rate based on the resolution.
If the maximum Bit Rate is set to a lower value than required by configured resolution, the framerate will be maintained
and the resolution will be reduced. For example, if the Maximum Bit Rate is set to 768Kbps, while resolution is set
to 1600x1200, Annexxus module will continue sending video at the set frame rate, but the resolution will be auto-
matically lowered.
Recommended Maximum Bit Rate based on Resolution
Recommended Max. Bit Rate
Resolution
512 Kbps
CIF (352x240/352x288)
768 Kbps
2CIF (704x240/704x288)
1024 Kbps
D1 (704x480/704x576)
1536 Kbps
1280x720
2048 Kbps
1600x1200
8. From the
BitRate Type
drop-down menu select either
Variable (recommended)
or
Fixed
BitRate type.
Variable bit rate type will continuously transmit video image, even when the available bit rate will fall below the
configured bit rate value (due to higher than normal network traffic, for example). If the bit rate type is set to Fixed,
no video image will be transmitted when the available bit rate falls below configured bit rate value.
To configure the Sub Stream settings, select
Sub Stream
from the
Type
drop-down menu and then repeat steps 2-8
above. Since sub video streaming is usually used to view the video faster over the Internet, it is recommended to set the
sub stream frame rate to higher values, while keeping the resolution setting low: QCIF or CIF.
Recommended FPS Setting
Recommended Resolution
Setting
35
Video Settings Setup
Chapter 2. Remote Connection via SRX-Pro/iP-Pro
Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at