i3 International S81, Руководство пользователя

Страница: 26 / 205

25
The Ports
This page displays the current port configurations as well as allowing management of those configurations.
To configure the Current Port configuration in the web interface:

Click Configuration / Ports Configuration / Ports.

Specify the speed Configured, Flow Control, Maximum Frame size, Excessive Collision mode and Power Control.

Click Apply and click the Save icon in the upper right corner to save the settings or click Reset to cancel. The
Form will return to the previously saved settings.
Port Configuration Parameters:
Items Description
Port This is the logical port number for this row.
Link The current link state is displayed graphically. Green indicates the link is up and red that it
is down
Current Link Speed Provides the current link speed of the port.
Configured Selects any available link speed for the given switch port. Only speeds supported by the
specific port are shown. Possible speeds are:
Disabled – Disables the switch port operation.
Auto – Port auto negotiating speed with the link partner and selects the highest speed that
is compatible with the link partner.
10Mbps HDX - Forces the cu port in 10Mbps half-duplex mode.
10Mbps FDX - Forces the cu port in 10Mbps full duplex mode.
100Mbps HDX - Forces the cu port in 100Mbps half-duplex mode.
100Mbps FDX - Forces the cu port in 100Mbps full duplex mode.
1Gbps FDX - Forces the port in 1Gbps full duplex
2.5Gbps FDX – Forces the port in 1Gbps full duplex mode.
SFP_Auto_AMS - Automatically determines the speed of the SFP. Note: There is no
standardized way to do SFP auto detect, so here it is done by reading the SFP rom. Due to
the missing standardized way of doing SFP auto detect some SFPs might not be
detectable. The port is set in AMS mode. Cu port is set in Auto mode.
100-FX - SFP port in 100-FX speed. Cu port disabled.
100-FX_AMS - Port in AMS mode. SFP port in 100-FX speed. Cu port in Auto mode.
1000-X - SFP port in 1000-X speed. Cu port disabled.