18
System Configuration
This section describes the basic configuration tasks which includes the System Information and any switch management
including setting the Time, Account, IP, Syslog and NTP settings.
System Information
The system can be identified by configuring the contact information, name, and location of the switch.
To configure the system’s contact information through the web interface:
•
Click Configuration / System / Information
•
Enter System Contact, System Name, System Location information on this form.
•
Click “Apply” and click the Save icon in the upper right corner to save the settings, or, click Reset to cancel. The
Form will return to the previously saved settings.
System Contact Information Configuration Parameters:
Items
Description
System Contact
The textual identification of the contact person for this managed node, together with
information on how to contact this person. The allowed string length is 0 to 128, and the
allowed content is the ASCII characters from 32 to 126.
System Name
An administratively assigned name for this managed node. By convention, this is the node's
fully-qualified domain name. A domain name is a text string drawn from the alphabet (A-
Za-z), digits (0-9), minus sign (-). No space characters are permitted as part of a name. The
first character must be an alpha character. And the first or last character must not be a minus
sign. The allowed string length is 0 to 128.
System Location
The physical location of this node (e.g., telephone closet, 3rd floor). The allowed string
length is 0 to 128, and the allowed content is the ASCII characters from 32 to 126.
IP ADDRESS
The IPv4 address for the switch could be obtained via DHCP Server for VLAN 1. To manually configure an address, you
need to change the switch's default settings to values that are compatible with your network. You may also need to
establish a default gateway between the switch and management stations that exist on another network segment.
Configure the switch-managed IP information on this page. Configure IP basic settings, control IP interfaces and IP routes.
The maximum number of interfaces supported is 8 and the maximum number of routes is 32.
To configure an IP address in the web interface.
•
Click Configuration / System / IP
•
Click Add Interface then create new interface on the switch.
•
Click Add Route then you can create new Route on the switch.
Содержание S81
Страница 113: ...112 NOTE Click the Port index to set the QoS Egress Port Schedulers...
Страница 117: ...116...
