Thank you for purchasing i3 International’s HE01ERK HDMI Cat5e/6 extender (sold in pairs). Use HE01ERK to carry HDMI video signal
for distances of up to 130 ft (40 m) at 1080p resolution (1920x1080) using a Cat5e/6 RJ45 Ethernet Cable.
Use with i3’s dDisplay license for convenient PVM monitor installations.
INSTALLATION
HDMI CAT5e/6 Extender
HE01ERK
User Manual
i3-TRNG-ACCESSORIES-
HE01ERK
.indd
Rev. 220913
FEATURES
• HDMI signal (1920x1080 / 1920x1200) extension up to
130 ft (40 m) over RJ45 Cat5e/6 cable.
• No external power required
• Built-in micro USB port for optional power supply
• Use with i3’s NVRs for convenient PVM installation.
PACKAGE CONTENTS
1.
HE01SET (Transmitter) x1
2.
HE01SER (Receiver) x1
3.
Micro USB to DC plug cable x1
Connect 5V power adapter (not included) using the Micro USB to
DC cable (provided) to HE01SET where HDMI sources does not
provide enough power to HE01SER.
i3 NVR
HE01SET
(Transmitter)
i3 INTERNATIONAL INC.
1.866.840.0004
www.i3international.com
REGULATORY NOTICES (FCC CLASS A)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the
limits of a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
130 ft
40 m
PVM Monitor
CONNECTORS
Figure 2.
HE01ERK panels,
parts description.
RJ45 straight connection
Figure 1.
HE01ERK connection diagram.
dDisplay Monitor #1
HDMI
1
2
4
3
1.
Micro USB connector
(HE01SET Transmitter only). Connect
Micro USB to DC cable (provided) where HDMI source does
not provide enough power to Receiver.
Note: 5V power adapter not provided.
2.
HDMI connector.
Connect HE01SET to on-board HDMI
connector on an i3 NVR, connect HE01SER to the HDMI
monitor.
3.
Power LED Indication.
Indicates device power status.
See Table 1.
4.
RJ45 Connector.
Use the straight CAT5e/6 cable, to connect
the HE01ERK devices.
See Tables 2, 3.
IMPORTANT
• Using high quality CAT5e/6 UTP cable for all transmission
ranges over 98 ft (30 m).
• Do not use STP or flat cable to avoid video loss
• Keep the cabling away from electromagnetic waves, i.e.:
microwaves, radio equipment, high voltage power lines, etc.
• Maximum supported distances will vary based on the
equipment.
• Do not coil the cable to avoid crosstalk interference.
• HDCP is not supported.
• This is not a networking product, do not connect with any
Ethernet device.
Figure 3.
HE01ERK front and back panels
HE01SER
(Receiver)
